Kongskilde SB 2005, Operator'S Manual, Page: 45 / 104

4 - OPERATING INSTRUCTIONS
Starting the unit
Connection to the tractor
Placing sideways
It is possible to adjust the implement to the track width of
the tractor in three ways
(A) , (B) , or (C) .
ZEIL18HT00681AA
1
Connection
1. Place the tractor right in front of the three-point linkage
of the implement.
2. Adjust the link arms of the tractor so that the link arms
are at the same height.
3. Carefully reverse the tractor while lifting the link arms
until the draw pins of the implement can be connected
to the tractor. Connect the pins.
4. Mount the top link of the tractor and place it as parallel
to the link arms of the tractor as possible.
5. Connect the lifting cylinder to the single-acting hy-
draulic outlet of the tractor.
6. Lock the link arms of the tractor to prevent them from
moving sideways.
Adjustment of depth stop on the link arms
The depth stop (1) on the link arms must be adjusted so
that there is 2 cm ( 0.8 in ) oblong hole above the pin in the
relief device.
ZEIL18HT00683AA
2
4-5