Kongskilde SB 2005, Operator'S Manual, Page: 44 / 104

4 - OPERATING INSTRUCTIONS
Test drive
Connect the PTO shaft carefully and let the engine run at
a low number of RPM for some minutes.
If there is no unintended noise or unusual vibrations, the
speed can gradually increase to normal number of RPM
of
540 RPM . Apart from the tractor driver nobody should
stand near the implement.
Before the implements leave the factory, the implements
have a test for vibrations. This is an essential part of the
company quality assurance.
It is, however, necessary to check regularly whether the
implement has unnatural vibrations, especially during test
driving.
NOTICE: When discs and blades rotate with 3000 RPM ,
even slightly damaged rotating parts (blades, discs and
caps) may result in vibrations which in the long run may
lead to secondary damage such as cracks or fractures.
Even though you secure the implement against impacts
and vibration damage, there are always a certain risk,
though limited.
During the season check daily if blades, discs and caps
are damaged and replace parts if necessary.
4-4