Kongskilde SB 2005, Operator'S Manual, Page: 26 / 104

2 - SAFETY INFORMATION
Stopping the implement safely
WARNING
Moving parts!
Some components may continue to run after
disengaging the drive systems.
Make sure
all drive systems are fully disengaged and all
movement has stopped before servicing the
machine.
Failure to comply could result in death or se-
rious injury.
W0002A
Always interrupt the operation of the implement before
you leave the tractor seat.
For safety's sake never leave the tractor cab without first
to disengage the Power Take-Off (PTO) drive mechanism
and to stop the tractor engine. Furthermore, if you leave
the tractor unattended, always remove the ignition key.
Stop the tractor engine and the PTO drive and wait until
the implement has completely stopped before you open
any of the guards. There are rotating parts under the
guards which may continue rotating after the implement
has been stopped. Keep a safe distance until the imple-
ment has come to a complete standstill. Look and listen
for evidence of rotating parts before you open any of the
guards.
Never leave the tractor before the cutting unit is resting on
the ground, the engine of the tractor has stopped, and the
parking brake has been activated. This is the only way to
perform a safe operation.
Do not try to lift the guard of the cutting unit until all re-
volving parts have stopped.
Make sure to secure the tractor by means of the hand
brake and/or stop blocks if you need to stand between
the tractor and the implement.
When, due to exceptional circumstances, you decide to
keep the tractor engine running after you leave the tractor
cab, you must:
• Bring the tractor engine to low idle speed.
• Disengage all drive systems.
• Shift the tractor transmission into neutral.
• Apply the parking brake.
When you park the implement there are some operational
risks which may cause personal injury. Therefore, you
must:
• Make sure that the ground is firm and even during park-
ing.
• Make sure that tractor and implement cannot move.
• Always lower the implement to the ground.
• Stop the tractor engine and remove the ignition key.
• Use correct support or transport safety device when the
implement is parked. Make sure that the parking stand
is secured.
When you detach the implement from the tractor:
• Never allow anyone to stand between the tractor and
the implement. An unintentional manoeuvre with the
tractor may cause serious injury.
• Always stop the PTO and the tractor engine and re-
move the ignition key before you disconnect the PTO
drive shafts.
• Unless the protective guards, the PTO drive shaft may
cause serious injury. Be careful not to damage the
guards when you disconnect the PTO drive shaft from
the tractor.
• Never allow the PTO drive shaft guards to fall into the
implement or drop to the ground, damage will almost
certainly occur.
• After you remove the PTO shaft, place the guard on the
tractor PTO.
• Always detach the implement carefully and on a flat
surface to prevent damage.
• Never go under an unsupported implement.
2-10