Kongsberg Simrad ST90, Reference Manual

Page: 529 / 690

442704/A
527
Port
Select the Ethernet port or serial port you want to use for the communication.
Inspect Port
Select
Inspect Port
to check the communication parameters for the port. The relevant
port setup dialog box opens. You are not permitted to make any changes.
You can not define the communication port parameters here. If you need to adjust
these, you must select
I/O Setup
after you have defined the data output parameters.
The
I/O Setup
page is located in the
Installation
and
Output
dialog boxes.
Monitor
Select
Monitor
to open the
Port Monitor
dialog box. The
Port Monitor
dialog box
allows you to study the communication stream on the chosen serial line or local area
network (LAN) port.
Add
Select
Add
to start export of the chosen data format. Once an output type has been
defined, it is listed in the
Installed Outputs
box on the left side of the page.
Remove
Once an output type has been defined, it is listed in the
Installed Outputs
box on the
left side of the page. To remove the output, select the relevant format in the
Installed
Outputs
box, and then select
Remove
.
Edit
Once an output type has been defined, it is listed in the
Installed Outputs
box on the
left side of the page. To edit the settings of a specific output, select it in the
Installed
Outputs
box, and then select
Edit
. Once you have finished editing the output settings,
select
Save
to keep the changes.
Save
Once you have finished editing the output settings, select
Save
to keep the changes.
Related topics
Exporting sensor data, marker positions and technical information, page 181
Functions and dialog boxes, page 416
Operation menu; Functions and dialog boxes, page 430
Output dialog box, page 438
Functions and dialog boxes