Kongsberg Simrad SN90, Installation Manual

Page: 42 / 298

40
381298/C
5 Power up the SN90 for the first time, and set it to work.
Note
In order to set up the SN90 in a safe and correct manner, these procedures must be
complied to!
6 Connect the peripheral units.
7 Run a complete system test.
Further requirements
Fill in and sign the Installation Remarks form, and send it to Simrad's support department
as specified on the form.
About installation drawings
The installation shipyard must provide all necessary design and installation drawings, as
well as the relevant work standards and mounting procedures.
Note
If required, all documents provided by the shipyard for the physical installation of the
SN90 must be approved by the vessel’s national registry and corresponding maritime
authority and/or classification society. Such approval must be obtained before the
installation can begin. The shipowner and shipyard doing the installation are responsible
for obtaining and paying for such approval.
Kongsberg Maritime offers free advice for installation planning. Proposed arrangements
may be sent for commentary or suggestions. The following drawings should be
submitted should assistance be requested:
• General arrangement
• Body plan and drawings of the relevant compartment
• Lines plan
Relevant outline dimensions and production drawings can be download from our
website. Most documents are available in PDF and/or AutoCad (DWG) formats.
• http://www.simrad.com/sn90
Simrad SN90