Kongsberg Simrad SN90, Installation Manual

Page: 265 / 298

381298/C
263
2 Lift the unit out of the transportation box.
3 Place it in a stable position on the floor/work bench.
4 Inspect the unit for visual damage.
5 Remove any packing material that may be inside the unit.
6 Collect and keep the relevant user manuals and/or documents provided with the unit.
Related topics
Unpacking standard parts and units, page 261
Unpacking electronic and electromechanical units
Prior to installation or use, electronic and electromechanical units must be unpacked
from their transport boxes. It is important that this unpacking is done without inflicting
damage to the equipment.
Prerequisites
Observe the procedure for unpacking of standard parts and units.
Context
Electronic and electromechanical units will normally be wrapped in a clear antistatic
plastic bag.
Do not break the seal to open a circuit board package before the board is to be used. If
the board package is returned to the manufacturer with the seal broken, the contents will
be assumed to have been used and the customer will be billed accordingly.
Note
When you handle electronic circuit boards and modules, you must beware of the dangers
of electrostatic discharge (ESD), both to yourself and to the equipment. In order to
ensure safe transport and storage, circuit boards and other electronic units will always
be wrapped in a clear plastic protective bag, and the bag will be sealed.
Procedure
1 Lift the unit, in its bag, out of the box.
Note
Cables must
never
be used as carrying handles or lifting points.
2 Place it in a stable position on the floor or a work bench.
3 Inspect the unit for visual damage before opening the antistatic plastic bag.
Equipment handling