Kongsberg Simrad MF90, Installation Manual

Page: 246 / 426

244
476671/B
Related topics
Setting to work, page 186
Turning on the MF90 system for the first time, page 243
Turning on the entire system: Preparations
Before you can turn on the entire MF90 system, you must connect the transducer cable,
and prepare the hull unit for remote control.
Prerequisites
The MF90 system is installed as specified in this manual.
• The door on the Transceiver Unit is removed.
• Neither tools nor instruments are required.
Context
Certain steps in the procedures are location specific. The steps marked [ Sonar room ] are
done in the sonar room. The steps marked [ Bridge ] are done on the bridge.
Procedure
1 Make sure that all Ethernet cables are connected.
2 Make sure that the transceiver plug has been firmly connected to the dedicated socket
on the left side of the Transceiver Unit.
3 Make sure that the transducer can be lowered and hoisted without complications or
obstacles.
4 Make sure that the transducer cable can move freely when the transducer is lowered
and hoisted.
5 Use a spanner to open the door on the Motor Control Unit.
6 Locate the
Hoist/Lower Switch
(S302).
7 Set the switch to position REMOTE .
Related topics
Setting to work, page 186
Turning on the MF90 system for the first time, page 243
Simrad MF90 Installation Manual