Kongsberg Simrad EK80, Installation Manual

Page: 197 / 354

394149/D
195
Result
Requirements Results
The Wide Band Transceiver (WBT) is correctly installed with easy access
for maintenance and replacement of parts.
The Wide Band Transceiver (WBT) is free from scratches, dents or other
physical damage.
Free access to all the connectors on the Wide Band Transceiver (WBT) are
provided. All cables connected to the Wide Band Transceiver (WBT) are
properly mounted with enough slack.
The welds and brackets that support the Wide Band Transceiver (WBT)
are strong enough to hold the unit securely in place under all operating
conditions. The welds and brackets have been painted with the correct
preservation medium to prevent corrosion.
The Wide Band Transceiver (WBT) is properly grounded.
Date and signature:
Related topics
Making sure that the EK80 is ready for operational use, page 188
Visual inspection of the WBT Cabinet
A visual inspection of the WBT Cabinet is required to verify that it has not been
physically damaged during the installation.
Prerequisites
The EK80 hardware units are installed as specified in this manual. The EK80 is turned
off. You need the following equipment:
• Multimeter
Procedure
1 Make sure that the WBT Cabinet is installed in the correct location, and that it is
suitably oriented for easy maintenance and replacement of parts.
2 Make sure that the physical installation of the cabinet has been completed.
a Make sure that the compartment ("sonar room") is provided with ample
ventilation to prevent system units from overheating.
b Make sure that the compartment ("sonar room") is clean and dry.
c If applicable: Make sure that the bulkhead structure to which the cabinet is
fastened is substantial enough to hold it securely in place under all operating
conditions.
d If applicable: Make sure that all welds and brackets have been painted with the
correct preservation medium to prevent corrosion.
Setting to work