Kongsberg Simrad CS90, Reference Manual

Page: 330 / 686

328
442700/A
Tip
The
Bearing
function controls the horizontal direction of the Vertical view and the
inspection beam.
• If you use a presentation mode with two horizontal views you can set
Bearing
to
two different values. Both bearings are shown as continuous lines pointing out
from the sonar position. Each bearing is shown with a solid line.
• If you use a presentation mode with two vertical views you can set the
Bearing
function to two different values. Both bearing lines are shown in the Horizontal
view. The bearing for the Vertical view is shown with a solid line. The bearing for
the Vertical 2 view is shown with a dotted line.
A new manually initiated tracked object is automatically given priority status. The
priority is identified with a "P". The bearing and tilt settings are automatically adjusted
to follow the movements of the tracked target. The bearing line is automatically
locked on the object to reflects its bearing.
Range
/
Range Rings
/
Variable Range Ring
The distance from the vessel symbol in the centre of the circle to the outer ring
corresponds to the currently selected range.
The current settings for range, gain and tilt are shown in the upper left corner of the
view. Click on the text to make it larger. Click one more time to restore the original
font size.
Range rings are a set of concentric circles labelled by distance from the vessel
position. The selected range is divided into identical distances. The range rings are
shown as dotted lines. Each ring has a range read-out. Use the
Range Rings
function to
toggle the range rings On or Off .
Variable Range Ring
adds an adjustable range ring to the view. The ring is shown as a
dotted circle with its centre on the vessel symbol. The current range is shown next to
the circle. To change the range, left-click on the circle and drag to requested diameter.
You can use
VRR Range
to manually define a range. The variable range ring can be
used for any type of distance measurement relative to the sonar.
Tilt
The current settings for range, gain and tilt are shown in the upper left corner of the
view. Click on the text to make it larger. Click one more time to restore the original
font size.
When you change the tilt a dotted line presents the requested tilt while the solid line
presents the actual tilt. You can change the tilt angle by means of the
Tilt
function on
the
Main
menu. You can also click on the tilt line in a Vertical view and drag it up and
Simrad CS90 Reference Manual