Kongsberg Simrad CP200-5C, Installation Manual

Page: 21 / 110

484164/A
19
If you find suspicious damage, take high resolution photos that show the damage.
Contact your dealer or the Simrad support organization for advice.
5 If necessary, apply anti-fouling paint as described in the dedicated procedure.
Note
Because some paint types may be aggressive to the polyurethane in the transducer,
consult our list of approved paints. The list of approved anti-fouling paints can be
found on our website.
• https://www.kongsberg.com/anti-fouling-paints
Related topics
Transducer handling and maintenance, page 15
Approved anti-fouling paints, page 21
Painting the transducer face
Marine growth (biological fouling) on the transducer face reduces the performance. We
recommend that you paint the transducer face immediately after installation, and then again
as often as required to maintain the protection.
Prerequisites
The following tools and consumables are required:
• Personal protection
• Fresh water
• Plastic brush
• Mild synthetic detergent
• Piece of wood or plastic without sharp corners
• Primer
• Anti ‑ fouling paint
• Wet film gauge
• Airless spray
Transducer handling and maintenance