Kongsberg Seatex Seapath 200, Installation Manual

Page: 31 / 130

Seatex Seapath 200 Installation Manual, rev. 13 Installation
17
7. Insert the MRU into the bracket. In order to achieve the orientation as shown in Figure 5,
the MRU must be rotated in the bracket. Apply Loctite 242 glue or equivalent on the four
MRU screws (3).
Note
The MRU R+ arrow must always point in the bow direction unless the default
mounting orientation of the unit is modified in the MRU configuration.
8.
Apply the sticker (4) onto the bracket according to the actual mounting direction of the
MRU, as shown in Figure 7. In this way, the actual mounting direction is identified in
case the unit is to be exchanged or removed temporarily.
Figure 7 Sticker (4) shall indicate actual mounting orientation of MRU within bracket
Note
If the MRU is mounted correctly in the bracket, the +R arrow on the top of the
MRU will point in the bow direction of the ship and the same direction as the R-
axis of the sticker. If uncertain whether the MRU R-axis is pointing in the bow
direction, look under the MRU and check that the +R arrow label is pointing in
the bow direction. Precise MRU orientation is important to ensure that high
quality and accurate measurements are available to the host system.
9. Mount the junction box on the wall in a suitable location within the length of the 3-metre
MRU-E-CS1 cable, as shown in Figure 8. The screws for mounting the junction box
should be secured with washers or self-locking nuts.