Kongsberg Seapath 320, Technical Manual

Page: 49 / 100

Technical Description
Man_techn_seapath320/rev.1 35
3.3.6 Cabinet mounting
3.3.6.1 Mounting Seapath with delivered cabinet
The cabinet should be securely mounted. Drilling plan for the resilient mountings is
included in the attached drawings.
Caution The cabinet must be connected to a grounded outlet.
It is recommended that the cables attached to the rear of the unit should be long enough
to accommodate all service from the front.
The cabinet must be mounted in such a way that the minimum cable bends (on the rear
side) are not exceeded. For the antenna cables it may be necessary to use the short
transition RG-213 or RG-214 cable in order to route the cables properly into the cabinet.
3.3.6.2 Mounting Seapath without delivered cabinet
A system delivered without a cabinet shall be mounted on attachment rails in a standard
19-inch rack. Minimum depth of the rack is 500 mm. It is recommended that the rack is
resiliently mounted.
It is recommended that the rack has air inlet on top and bottom or ventilation splits on
the sides. The Processing and HMI units have ventilation on the sides. Forced
ventilation may be required if the cabinet contains several electronic modules.
All cables connected to the unit must be screened. Make sure that the minimum antenna
cable bends are not exceeded.
Note
The recommended keyboard cable length is 3.3 m (10 feet) maximum
without degradation. If longer keyboard cable is needed, please use
keyboard extender.