52
922-20297011/1.0
Setting to work summary
Once all the hardware units have been installed, and all the cables have been connected, the
M3 Sonar FLS can be turned on for the first time, and set to work.
Prerequisites
• All M3 Sonar FLS hardware units have been installed according to the relevant
instructions.
• All system cables have been installed.
• All connections have been made.
• All operating power is available.
Procedure
1
Make sure that the M3 Sonar FLS is ready for operational use.
a
Make sure that the operational power is correct.
b
Make sure that all hardware is properly installed.
c
Make sure that all M3 Sonar FLS cables are properly connected.
2
Power up the M3 Sonar FLS for the first time.
3
Configure the M3 Sonar FLS for operational use.
a
If required, set the Sonar Processor to High Performance.
b
If required, install the M3 Sonar FLS operational software.
c
If required, define the IP address on the Sonar Processor network adapter.
Note
If you have a unique network environment (such as an IP Address conflict between
two devices on your network), or you are installing a second Sonar Head, then
you will need to change the IP Address of the Sonar Head. Refer to the M3 Sonar
FLS Reference Manual for more information.
4
Test the M3 Sonar FLS operational functionality.
To make sure that the M3 Sonar FLS meets all operational and functional requirements,
specific tests are required.
M3 Sonar FLS Installation Manual
Summary of Contents for M3 Sonar FLS
