Kongsberg Flexview, Installation Manual

Page: 117 / 126

922-20207011/1.0
115
13 If the unit contained in a box holds normal batteries, these may have been
disconnected/isolated before the unit was packed. These must only be reconnected
before the installation starts. Units containing batteries are marked.
Caution
Units containing lithium or alkaline batteries must be handled separately and with care.
Such units are marked accordingly. Do not attempt to recharge such batteries, open them,
or dispose of them by incineration.
Refer to the applicable product data sheets or battery handling procedures for further
details.
Temperature protection
Any units that requires protection against extreme temperatures are identified as such in
the applicable documentation. The box used to transport and store such units are clearly
marked, for example:
Must not be transported or stored in temperatures below -5 °C.
Other temperature limits may be used if applicable.
If a unit needs temperature protection, the box to be used for storage and transportation must
be lined on all walls, base and lid, using minimum 5 cm thick polyurethane or polystyrene
foam.
Most system units can normally be stored in temperatures between -30° C and +70° C. Refer
to the relevant technical specifications for details.
Note
Unless otherwise specified, transducers and hydrophones must not be stored in temperatures
below −10°C and above +50°C.
Unpacking standard parts and units
Prior to installation or use, parts and units must be inspected, and then unpacked from their
transport boxes. It is important that this unpacking is done without inflicting damage to
the equipment.
Context
This procedure provides the basic tasks of unpacking units (main unit, spare parts etc) from
boxes shipped from Kongsberg Mesotech.
Equipment handling