Kongsberg EA640, Installation Manual

Page: 19 / 94

413764/B
19
About installation drawings
The installation shipyard must provide all necessary design and installation drawings, as
well as the relevant work standards and mounting procedures.
Note
If required, all documents provided by the shipyard for the physical installation of the
EA640 must be approved by the vessel’s national registry and corresponding maritime
authority and/or classification society. Such approval must be obtained before the
installation can begin. The shipowner and shipyard doing the installation are responsible
for obtaining and paying for such approval.
Kongsberg Maritime offers free advice for installation planning. Proposed arrangements
may be sent for commentary or suggestions. The following drawings should be
submitted should assistance be requested:
• General arrangement
• Body plan and drawings of the relevant compartment
• Lines plan
Tools, equipment and consumables required
for EA640 installation
In order to do the EA640 installation, all necessary tools and equipment for mechanical
work, cabinet installation and electrical wiring must be available.
It is not practical to provide a detailed list of all necessary tools and equipment. You must
be equipped with a standard set of tools. This tool set must comprise the normal tools
for electronic and electromechanical tasks. This includes different screwdriver types,
pliers, spanners, a cable stripper, a soldering iron, etc. Each tool must be provided in
various sizes. We recommend that all tools are demagnetized to protect your equipment.
However, you must make sure that the following specialized tools are available.
• All necessary tools and consumables required for welding
• All necessary tools and consumables required for physical installation of units,
cabinets and racks
• All necessary tools and consumables required for electrical installations
Preparations