Kongsberg cNODE MiniS, Instruction Manual

Page: 20 / 62

20
397152/E
Result
The transponder is ready for use.
Deployment
The transponder is designed for operation in water only. The transponder may be
operated in air for test purposes over a short period of time.
Prerequisites
The transponder must be charged before use. It is recommended to test the transponder
with the Test and Configuration unit (TTC) to make sure it is working properly before
operation.
Description
When you fit the transponder onto a vehicle/structure, the unit must be positioned with
the transducer upright and there must be a clear line of sight between the transducer on
the transponder and the vessel’s transducer. Use a hose clamp with rubber protection to
secure the transponder.
Internal tilt sensor
The transponder has an internal tilt sensor, where forward is towards the embossed
logo, and upwards is toward the transducer.
Recovering the transponder
It is important to perform these recovery checks after every operation.
Procedure
1 Wash the unit thoroughly in warm fresh water to dissolve any salt deposits and
clean off any sand or silt.
2 As an extra precaution, it is recommended that the unit is left to soak in fresh water
to allow salt to dissolve and diffuse from hard-to-reach areas, such as crevices
between mating parts.
Leave the unit to soak for 24 hours, or as long as practical conditions allow.
3 Dry off the unit and make sure that there is no water around the on/off plug or
the external connector.
4 Turn the unit off by removing the on/off plug or disconnecting the external cable.
cNODE MiniS Instruction Manual