Komatsu WB93R-5, Operation & Maintenance Manual

Page: 143 / 284

TRANSPORTING THE MACHINE ON OTHER VEHICLES
141
3.9 TRANSPORTING THE MACHINE ON OTHER VEHICLES
3.9.1 LOADING AND UNLOADING THE MACHINE
WARNING
q
The loading and unloading of the machine on-off the means of transport must be carried out on a flat
surface and at a safety distance from the edges of ditches or from the roadside.
q
Block the means of transport by positioning wedges before and behind each wheel.
q
Make sure that the ramps are sufficiently strong; if necessary, reinforce them with blocks, in order to
prevent any dangerous bending.
q
Make sure that the ramps have the same length, are firmly anchored to the vehicle, are parallel to each
other and perpendicular to the loading board; the distance between the ramps must be suitable for the
wheel gauge of the machine.
q
Position the ramps with a maximum inclination of 15°.
q
Remove any trace of oil, grease or ice from the ramps and the loading board.
q
Do not change direction when the machine is already on the ramps; if necessary, go down and find the
correct direction.
1 - The machine must get on the ramps with the front bucket (1) directed forward and lifted from the ground.
2 - After loading the machine on the truck, lower the front bucket to the ground, shift the gears into NEUTRAL and
apply the parking brake.
3 - Lower the backhoe bucket (2) onto the vehicle, lower the stabilizers (3), lock the loader control and the back-
hoe control levers.
IMPORTANT
q
On machines equipped with backhoe servo controls, the movements of the levers are inhibited by the
front loader locking button (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON").
4 - Stop the engine and remove the ignition key.
5 - Secure the machine in the correct position by putting wedges (4) before and behind each wheel.
Max. 15°
RKA14630
1
5
2 3
4 4
B
6
5
A
https://tractormanualz.com