Komatsu WA100M-7, Operation And Maintenance Manual

Page: 6 / 304

1.1 Foreword Foreword
1-4
WA80M-7, WA100M-7 – VENAM03001
EU Directives
Machines delivered by Komatsu are compliant with the Machine
Directive 2006/42/EEC and its amendments. If the machine is
used in another country, it is possible that certain safety devices
and specifications may not be compliant with the requirements
applicable in the country of use. For example, warning beacons
may be used in some countries while being prohibited in others.
If there is any question about whether your product complies with
the applicable standards and regulations of your country, consult
your Komatsu distributor before operating the machine.
Notes on subsequent installation of electrical and electronic
equipment and components
Electrical and electronic equipment and/or components installed
after delivery emit electromagnetic radiation which may possibly
influence the function of the electronic components and assem-
blies of the machine. This may affect the safety of the machine or
endanger persons. For this reason, please ensure that the follow-
ing safety instructions are observed.
If you are installing electrical or electronic equipment and/or com-
ponents in the machine and connect them to the vehicle's electri-
cal system, you are obliged to have the installation verified for not
interfering with vehicle's electronic system or other components.
In particular, please ensure that any subsequently installed elec-
trical and electronic components comply with the EMC Directive
2004/108/EC in its currently valid version and that they have CE
marks.
The following requirements also have to be met for subsequent
installation of mobile communication systems (e.g. radio, tele-
phone):
 Only equipment approved by national legislation (e.g. BZT
approval for Germany) may be installed.
 The unit must be fixed in position.
 Portable or mobile units may only be used inside the vehicles
if they are connected to a fixed outside antenna.
 The transmitter unit must be spatially separated from the
vehicle’s electronic system.
 Ensure that the antenna is installed properly with a good
earthing connection between the antenna and the vehicle
earth.
Also observe installation instructions by Komatsu or the manufac-
turer for wiring, installation and maximum permitted power con-
sumption.