Komatsu PW118MR-11, Operation & Maintenance Manual

Page: 278 / 462

When ascending a slope, the bucket must always be upstream
of the tractor unit.
When operating on slope
• Never perform the swing operation on a slope by using the left work equipment control lever if the engine is
stopped. Otherwise, the upper structure will swing under its own weight.
• Do not open or close the slide door while traveling or operating the machine on a slope. The operating force
may vary suddenly.
Always keep the door locked in place.
• Pay close attention when opening or closing the sliding door while the machine is idle. The door opens or
closes suddenly under its own weight, and it is dangerous.
• Before working on a slope or traveling on a rough ground, check DEF tank and add sufficient amount of
DEF as necessary. If the remaining DEF level becomes low, sudden drop of its level or abnormality in urea
SCR system may be detected. If DEF level caution lamp or DEF system caution lamp lights up in red, move
the machine to a level place immediately and add DEF.
METHOD FOR ESCAPING FROM MUD
Always operate carefully to avoid getting stuck in mud. If the machine does get stuck in mud, do as follows to
get the machine out.
When one side only gets stuck
NOTICE
When the boom and arm is used to lift the machine, always place the lower part of the bucket in contact
with the ground. (Never push with the bucket teeth.)
The angle between the boom and arm must be between 90 and 110 degrees.
The same applies when using the bucket installed in the reverse direction.
1.
Raise the wheels using the bucket and place boards or
blocks under the wheels so the machine can exit.
The wheels raise.
2.
Raise the bucket and escape.
When both sides are blocked
When both wheels are blocked in the mud, pull out the machine according to the following procedure.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-206
WENAM00130