Komatsu PW118MR-11, Operation & Maintenance Manual

Page: 357 / 462

3.
Lower the work equipment to the ground.
4.
Apply the parking brake.
5.
Set the lock lever to LOCK position (L).
6.
Stop the engine.
7.
Remove the cab mats and remove the drain plug (2).
8.
Wash the floor with running water without pressure and al-
low the dirt to drain through the hole (1).
9.
After washing is completed, dry the floor and the control
pedals if necessary; replace the cap (2) and mats.
Machine with blade
NOTICE
During the operation, be careful not to get water on the monitor, connector, air conditioner and its filter
inside the operator's cab.
1.
Stop the machine on a solid flat surface and turn the cab so that the blade is to the rear of the machine.
2.
Raise the blade; place a non-slip block of about 20 cm in height under the right side of the blade.
3.
Lower the blade until the rear wheel raises.
4.
Lower the work equipment to the ground.
5.
Apply the parking brake.
MAINTENANCE MAINTENANCE PROCEDURE
4-29
WENAM00130