Komatsu PC80MR-5E0, Operation & Maintenance Manual

Page: 372 / 412

2.
Select attachment mode “ATT/P” or “ATT/E” with function
switches “F1” or “F2” or “F5”.
3.
While attachment mode “ATT/P” or “ATT/E” is selected,
press function switch “F4” or leave it as it is for 5 seconds.
Attachment mode is set to “ATT/P” or “ATT/E”, and the
screen returns to the standard screen.
REMARK
To return to the standard screen without changing the
working mode, press function switch “F3”.
ADJUST OIL FLOW RATE OF GENERAL ATTACHMENT SUCH AS CRUSHER
ETC
• Attachment flow rate can be adjusted in 8 levels (“8” to “1”).
“8” is the maximum flow rate and “1” is the minimum flow rate.
Approximately 5 ℓ/min per level can be changed.
• For the adjustment method for flow rate of general attachment such as crusher, see “ATTACHMENT SET-
TING”.
METHOD FOR OPERATING GENERAL ATTACHMENT SUCH AS CRUSHER ETC
k k
WARNING
If you do not perform breaker operation or 2-way attachment operation, set the working mode to normal
mode.
When the working mode is selected, if you press 1st-line attachment proportional switch or breaker op-
eration switch by mistake, this may lead to serious personal injury or death.
1.
Check that the working mode is set to attachment mode
ATT/P or ATT/E on the machine monitor.
2.
Operate attachment 1 proportional switch.
The attachment operates.
HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT ATTACHMENTS AND OPTIONS
6-24
WENAM00241