Komatsu PC210-10 DEMOLITION BASE SPEC., Operation & Maintenance Manual, Page: 197 / 458

OPERATION EXPLANATION OF COMPONENTS
3–127
BATTERY DISCONNECT SWITCH
BATTERY DISCONNECT SWITCH:PC-AW1P-043K00A
k
CAUTION
If you have turned the battery disconnect switch to the OFF position, be sure to pull out the switch key.
If someone turns the key to the ON position carelessly, this is extremely dangerous.
NOTICE
q
Keep this switch in the ON position, except the following cases.
q
When the machine is stored for a long time (more than a month)
q
When the electrical system is repaired
q
When an electrical welding is conducted
q
When the battery is handled
q
When the fuse is replaced
q
Do not turn this switch to the OFF position while the system operating lamp is lighting up. The electri-
cal system may have trouble or abnormality.
q
If this switch is turned to the OFF position, all the electrical system is cut out and the functions of
KOMTRAX stop. In addition, the time information of the clock and the radio station select information
may be lost. In this case, see "CLOCK ADJUSTMENT (3-68)"and "OPERATION METHOD (3-119)"and
set again.
Use switch (1) to cut out the electricity from the battery.
This switch is installed inside the cover on the left side of the
machine.
Raise rubber cover (2), and the switch is seen.
REMARK
Operate this switch while system operating lamp (3) is OFF.
(O): OFF position
Switch key (1) can be pulled out (and inserted) and the current
from the battery is cut out.
(I): ON position
The electricity of the battery flows into the circuit.
Before starting the machine, be sure to set the switch to this
position.