Komatsu PC210-10 DEMOLITION BASE SPEC., Operation & Maintenance Manual

Page: 190 / 458

EXPLANATION OF COMPONENTS OPERATION
3–120
4. Flash the item to be adjusted, and press the tuning/time adjust button (4) and start the adjustment.
5. If display selection button (6) is pressed during the minute adjustment, the time adjustment will be released
and the time display will resume.
ANTENNA
Antenna:PC-K861-822K00A
Before transporting the machine putting it inside a building, stored the antenna to prevent any interference. Stow
the antenna as follows.
Loosen antenna mounting bolt (1) and store the antenna at
position (A).
After storing the antenna, tighten bolt (1).
USE RADIO WITH CARE
q
To ensure safety, always keep the sound to a level where it is possible to hear outside sounds during
operation.
q
If water gets into the speaker case or radio, it may lead to an unexpected failure, so be careful not to get water
on the equipment.
q
Do not wipe the scales or buttons with benzene, thinner or any other solvent. Wipe with a soft dry cloth. Use a
cloth soaked in alcohol if the equipment is extremely dirty.
q
When the battery is replaced or battery disconnect switch is turned to OFF position, the settings for the preset
buttons are all cleared, so set them again.
SPACE FOR RADIO CASSETTE
SPACE FOR RADIO CASSETTE:PC220_KU-K831-041K00A
The radio cassette is not factory fitted. If fitment is required
then remove front cover (1) and connect speaker wires and
aerial to radio cassette.
Please contact your distributor for a fitting instruction.
If radio is fitted in this location, do not operate radio in LH con-
sole.