Komatsu PC210-10 DEMOLITION BASE SPEC., Operation & Maintenance Manual

Page: 361 / 458

MAINTENANCE MAINTENANCE SCHEDULE TABLE
4–51
REMARK
Sometimes some air is still left inside water separator (3) after air bleeding, but the engine can be started by oper-
ating feed pump (7) until its motion gets hard. The remaining air is naturally bled when the water separator is left
as it is for a while after the engine stops.
CHECK SWING PINION GREASE LEVEL, ADD GREASE
CHECK SWING PINION GREASE LEVEL, ADD GREASE:PC-J136-218K00A
Prepare a scale.
1. Remove bolts (1) (2 pieces) on the top of the revolving
frame and remove cover (2).
2. Insert scale (3) into the grease through inspection and
adjustment hole (A). Check that the height of grease (S) in
the area where the pinion passes is at least 9 mm. Add
grease if the level is low.
3. Check if the grease is milky white. If it is milky white, it is
necessary to change the grease. Contact your Komatsu
distributor.
The total amount of grease: 14.6 litres.
4. Install cover (2) with bolts (1).