Komatsu PC210-10 DEMOLITION BASE SPEC., Operation & Maintenance Manual, Page: 266 / 458

MACHINE OPERATIONS AND CONTROLS OPERATION
3–196
1. When travelling down steep hills, use the travel lever and
fuel control dial to keep the travel speed low.
When travelling down a steep hill of more than 15°, set the
work equipment to the posture shown in the figure on the
right, and lower the engine speed.
2. When travelling up a steep hill of more than 15°, set the
work equipment to the posture shown in the figure on the
right.
q
When travelling up a steep slope, extend the work equip-
ment to the front to improve the balance, keep the work
equipment approximately 20 to 30 cm above the ground,
and travel at low speed.
BRAKING ON DOWNHILL SLOPE
BRAKING ON DOWNHILL SLOPE:PC-0000-18QK00A
Put the travel lever in the neutral position. This will cause the brake to be automatically applied.
IF ENGINE STOPS ON SLOPE
IF ENGINE STOPS ON SLOPE:PC-0000-18RK00A
If the engine stops when travelling uphill, move the travel levers to the neutral position, lower the bucket to the
ground, stop the machine, then start the engine again.
CAB DOORS ON SLOPE
q
If the engine stops when the machine is on a slope, never use the left work equipment control lever to carry out
swing operations. The upper structure will swing under its own weight.
q
Do not open or close the door when the machine is on a slope. The operating effort may suddenly change.
Always keep the door locked in position when it is open and when it is closed.