Komatsu PC210-10 DEMOLITION BASE SPEC., Operation & Maintenance Manual

Page: 204 / 458

EXPLANATION OF COMPONENTS OPERATION
3–134
7. This screen is displayed during the manual stationary
regeneration. It may take more than 40 minutes to complete
the manual stationary regeneration. Do not switch any
screen or operate fuel control dial until the regeneration is
complete and the standard screen appears again.
REMARK
q
The progress of the manual stationary regeneration per-
formed when soot is accumulated can be checked by the
number of lighting lamps of soot accumulation level (4). The
manual stationary regeneration starts at soot accumulation
level "4" or higher and finishes when all the level lamps go
out.
q
The time required for the manual stationary regeneration
depends on the soot accumulation level or the ambient tem-
perature when it is started. If the regeneration starts at soot
accumulation level "6" or higher, it may take approximately
two hours to finish.
q
The manual stationary regeneration for protection of the
system may start even when the soot accumulation level is
"0" to "3". In this case, the soot accumulation level may not
decrease, but this is not trouble. The progress is not dis-
played on the monitor during this regeneration. It is com-
pleted in about 10 minutes.
q
If the lock lever or fuel control dial is operated during the
manual stationary regeneration, the regeneration is stopped
automatically. Return the lock lever to LOCK position (L)
and return the fuel control dial to low idle position (MIN),
then repeat the procedure from Step 6.
q
If the machine needs to be moved during the manual sta-
tionary regeneration, stop the regeneration temporarily and
move the machine, referring to the KDPF regeneration disa-
ble and cancel procedures described below.
When restarting the manual stationary regeneration, secure
the safety of the machine and around it, then cancel the
regeneration disable.
8. After the manual stationary regeneration, the screen auto-
matically returns to the standard screen.
KDPF REGENERATION DISABLE PROCEDURE
If there is combustible material around the machine and the
forced regeneration that increases the exhaust temperature
must not be performed, the automatic KDPF regeneration can
be disabled. Also, the regeneration in progress can be
stopped.
NOTICE
Even if the regeneration is disabled, KDPF soot accumula-
tion monitor (1) lights up if soot is accumulated and the
manual stationary regeneration is required. If it lights up,
move the machine to a safe place and carry out manual
stationary regeneration.
If the work is continued without carrying out the manual
stationary regeneration, KDPF or the engine can have
trouble.