Komatsu PC200-8M0, Shop Manual, Page: 1126 / 1254

SEN06148-01
50-700
10
PC200, 200LC, 220, 220LC-8M0
700 Cab and its attachments
Removal and installation of operator cab glass (stuck
3) Stick dam rubber (6) for door lower win-
dow glass (3) to the position as shown in
the figure.
a
Stick dam rubber (6b) additionally to
door lower window glass (3).
q Positions to stick additional dam
rubber to the door lower window
class:
(j) : 110 mm
(k) : 90 mm
(m) : 200 mm
4) Stick dam rubber (6) for front window
glass (4) to the position as shown in the
figure.
a
Stick dam rubber (6c) of the lower
side of the front window glass along
the outside edge of the lower line, dif-
ferently from other dam rubbers (6).
(If it is stuck along the inside, it will be
seen through the transparent part of
the glass.)
5. Position the new window glass.
1)
Check the clearance between the window
glass and the operator's cab on the right,
left, upper, and lower sides, and then posi-
tion the window glass to be the clearances
evenly.
2) Stick tapes [6] between window glass (9)
and operator's cab (8) and draw position-
ing line (n).
a
Stick tapes [6] for positioning to 3
points, that is, right, left and lower
parts of the right side window glass,
left side rear window glass, and door
lower window glass for accurate posi-
tioning.
3) Cut the tape between window glass (9)
and operator's cab (8) with a knife, etc.
and then remove the window glass.
a
Do not remove the tapes left on the
window glass and the operator's cab
before installing the window glass.