Komatsu HB365LC-3, Operation & Maintenance Manual

Page: 473 / 506

This table lists the combination of attachments which can be installed to the long arm (standard) and
short arm.
○: Can be used,
△
: Can be used only for light duty work, ×: Cannot be used Mark: Equipped with side
cutter
Model
Capacity
m
3
Opening
width
mm
Use
6500 mm standard boom
Standard
Arm
3.2 m
Short
Arm
2.55 m
Ultra short
Arm
2.2 m
Long
Arm
4.0 m
* Narrow bucket 0.52 610
Narrow dig-
ging
○ ○ ○ ○
* Narrow bucket 1.14 1145
Narrow dig-
ging
○ ○ ○ ○
* Standard bucket 1.4 1340
General dig-
ging
○ ○ ○
△
* Light duty bucket 1.6 1515 Loading
△ △ △
×
Light duty bucket 1.8 1700 Loading
△ △ △
×
* Rock bucket 1.4 1458
For digging
soft rock
○ ○ ○ ×
Ripper bucket 0.9 950
Digging
rocks
○ ○ ○ ×
INSTALL ATTACHMENT
k k
WARNING
Depending on the type or combination of work equipment, there is a danger that the work equipment
may hit the cab or machine body.
When using unfamiliar work equipment for the first time, check before starting if there is any danger of
interference, and operate it with care.
Categories of use
Select a proper attachment for each use.
General digging
Digging or loading sand, gravel, clay etc.
Light duty digging
Digging and loading dry and loose sandy soil, or muddy soil.
Loading
Loading of dry and loose earth.
REMARK
For digging or loading hard soil or soft rock, it is recommended that the strengthened bucket with high durability
and high wear resistance be employed.
Combination of attachments
NOTICE
1. Bucket size based on ISO 7451, heaped material with a 1:1 angle of repose.
2. Max Bucket Volume/Weight are for reference only and are not necessarily available from the factory.
3. Table is based on General Purpose buckets and both conditions of Volume (m
3
) and Weight (kg) must not be
exceeded.
ATTACHMENTS AND OPTIONS ATTACHMENTS AND OPTIONS
6-31