Komatsu HB215LC-3, Operation & Maintenance Manual

Page: 318 / 492

1.
Remove the bolts (1), and remove the handrail (A) and
cover (2).
2.
Remove the bolts (3), and remove the handrail (B).
METHOD FOR INSTALLING HANDRAIL
Install handrail (B) first, then install (A).
1.
Install the handrail (A), then tighten it with bolts (3).
2.
Install the handrail (A) and cover (2), then tighten them with bolts (1).
Tightening torque: 98 to 123 Nm {10.0 to 12.5 kgm}
METHOD FOR REMOVING AND INSTALLING REVOLVING LAMP
METHOD FOR REMOVING REVOLVING LAMP
Remove the revolving lamp according to the following procedure.
1.
Remove connector (A) of the revolving lamp.
When removing the connector, pull it out while pressing
the claw in the center of the connector.
2.
Place the connector for wiring (B) in a clean vinyl bag or
the like to protect it from water, etc. during transportation
and fix it to the operator's cab with sealing tape or the like.
TRANSPORTATION OPERATION
3-246