Komatsu HB215LC-3, Operation & Maintenance Manual, Page: 276 / 492

3.
Invert the removed bucket.
4.
Align the pin hole of arm (1) with replacement bucket hole
(2), then align the pin hole of link (3) with hole (4), and in-
stall pins (A) and (B) which are coated with grease.
REMARK
When inverting, do not install the O-rings. Keep them until the next use.
5.
Install the stopper bolts and nuts for each pin, then grease the pins.
REMARK
• Lubricate with grease thoroughly until the grease comes out from the end faces.
• When replacing the bucket, replace the dust seal with a new one if it is damaged. If a damaged one is
used without being replaced, sand and dirt may enter the part of pin and cause abnormal wear of the
pin.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-204