Komatsu H75051, Operation & Maintenance Manual

Page: 233 / 440

Mirrors (A), (B)
Loosen bolt (1) of the mirror, then adjust the mirror to a position
which gives the best view from the operator's seat of the blind
spot at the right and left sides of the rear of the machine.
Adjust the mirror angle so that you can see a person who is
standing at the right or left rear end position of the machine (or
an object having the diameter of approximately 30 cm and the
height of approximately 1 m).
Install the mirror to a position where you can easily see the
hatched area in the figure.
The reference values of the visibility range are as follows.
Visibility range (left): 2500 mm
Visibility range (right): 2500 mm
Mirror (A) Hatched area (a) must be in view.
Mirror (B) Hatched area (b) must be in view.
METHOD FOR ADJUSTING REAR VIEW CAMERA
METHOD FOR ADJUSTING REAR VIEW CAMERA ANGLE
k k
WARNING
• Be sure to adjust the camera before starting work. If it is not adjusted properly, you cannot secure
the visibility and a serious personal injury or death may result.
• When adjusting the angle of the camera, prepare a scaffold first in order to provide a safe working
platform.
If you try to work standing on the counterweight, there is a danger of serious injury or death due to
falling off from the machine.
• Install only the Komatsu genuine camera.
OPERATION MACHINE OPERATIONS AND CONTROLS
3-167