Komatsu H75051, Operation & Maintenance Manual

Page: 165 / 440

FRONT WORKING LAMP SWITCH
k k
WARNING
The working lamps must be turned off when the machine is traveling on a public road.
Use the front working lamp switch to light up the front working
lamps.
Position (A): The working lamps light up.
Position (B): The working lamps go out.
When position (A) is pressed, the pilot lamp turns ON, and the
working lamps turn ON.
HAZARD LAMP SWITCH
k k
WARNING
When the machine is traveling normally, do not use this switch as it can mislead another vehicles.
Use the hazard lamp switch when you need to park the ma-
chine on a road due to machine failure or during emergency
only.
Position (A): The turn signal lamps and the turn signal pilot
lamp flash.
Position (B):The lamps go out.
DIRECTIONAL SELECTOR SWITCH
The directional selector switch is used to set the travel direction
to FORWARD, NEUTRAL, and REVERSE.
Position (F): FORWARD
Position (N): NEUTRAL
Position (R): REVERSE
The directional selector switch operates only when all of the fol-
lowing conditions are met.
• The directional lever is in NEUTRAL position (N).
• The directional selector switch actuation switch is in ON
position.
REMOTE POSITIONER SWITCH
The remote positioner switch is used to freely set the stopping position of the boom and bucket.
OPERATION EXPLANATION OF COMPONENTS
3-99