Komatsu Galeo PC800LC-8, Operation & Maintenance Manual

Page: 239 / 318

MAINTENANCE
MAINTENANCE PROCEDURE
4-19
MAINTENANCE PROCEDURE 4
INITIAL 100 HOURS MAINTENANCE (ONLY AFTER THE FIRST 100 HOURS) 4
Perform the following maintenance only after the first 100 hours.
q
Clean strainer of coupling lubricating oil filter
For details of the method of maintaining, see EVERY 500 HOURS MAINTENANCE.
INITIAL 500 HOURS MAINTENANCE (ONLY AFTER THE FIRST 500 HOURS) 4
Carry out the following maintenance only after the first 500 hours.
q
Change oil in swing machinery case
q
Change oil in couplig case
q
Change oil in final drive case
Special tools are needed for the inspection and maintenance, have your Komatsu distributor perform this work.
For details of the method of replacing or maintaining, see EVERY 1000 HOURS and EVERY 2000 HOURS SER-
VICE.
WHEN REQUIRED 4
CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT 4
WARNING
q
When using compressed air, there is danger of dirt flying and causing personal injury.
Always wear protective glasses, dust mask, or other protective equipment.
q
When removing the outer element from the air cleaner body, it is dangerous to pull it out by force.
When working in high places or where the foothold is poor, be careful not to fall because of the reac-
tion when pulling out the outer element.
NOTICE
q
Do not clean the air cleaner element until the air cleaner clogging monitor on the monitor panel
flashes. If the element is cleaned frequently before the clogging monitor flashes, the air cleaner will
not be able to display its performance fully, and the cleaning efficiency will also go down.
In addition, during the cleaning operation, more dirt stuck to the element will fall inside the inner ele-
ment.
q
If inspection, cleaning, or maintenance is carried out with the engine running, dirt will enter the engine
and cause damage to the engine. Always stop the engine before carrying out these operations.