Komatsu Galeo PC800LC-8, Operation & Maintenance Manual

Page: 162 / 318

MACHINE OPERATIONS AND CONTROLS
OPERATION
3-98
3. To complete the warm-up operation of the hydraulic equip-
ment more quickly, set the working mode to P mode
(heavy-duty mode).
For details of the procedure for setting the working mode,
see “Working Mode Selector Switch (Basic Switch) (3-20)“.
4. Move lock lever (3) slowly to the FREE position (F), then
raise the bucket from the ground.
5. Turn fuel control dial (4) to a point midway between low
idling (MIN) and full speed (MAX).
NOTICE
When the work equipment is retracted, take care that it
does not interfere with the machine body or ground.
6. Move right work equipment control lever (5) slowly in the
direction to pull in the bucket (D). Operate the lever to the
end of its travel and hold it in position for 30 seconds.
7. Move right work equipment control lever (5) slowly in the
direction to push out the bucket (C). Operate the lever to
the end of its travel and hold it in position for 30 seconds.
8. Next, move left work equipment control lever (6) slowly in the direction to pull in the arm (B). Operate the lever
to the end of its travel and hold it in position for 30 seconds.
9. Move left work equipment control lever (6) slowly in the direction to push out the arm (A). Operate the lever to
the end of its travel and hold it in position for 30 seconds.
10. Repeat the operation in Steps 6 to 9 for 5 minutes.