Komatsu D65EXi-18, Operation & Maintenance Manual

Page: 24 / 184

When the blade automatic control is automatically turned off,
pop-up message “Auto Control Disengaged!” is displayed on
the control box screen, and at the same time, notice sound
“Prr” is heard.
At this time, “AUTO” on the control box screen also goes out.
CUT/FILL OFFSETS SWITCH
Press the cut/fill offsets switches to adjust the cut/fill offset quantity setting quickly nearby.
The cut/fill offsets switches are located on the right side of the blade control lever.
For details of adjusting of cut/fill offset quantity setting, see “METHOD FOR ADJUSTING CUT/FILL OFFSETS
(4-77)”.
(1) Cut/fill offsets switch (Up)
(2) Cut/fill offsets switch (Down)
When cut/fill offsets switch (Up) (1) is pressed, cut/fill offset quantity setting increases. (Design surface rises.)
When cut/fill offsets switch (Down) (2) is pressed, cut/fill offset quantity setting decreases. (Design surface low-
ers.)
The increase/decrease amount when the cut/fill offsets switches are pressed is the same as the setting of the
“Cut/Fill offsets” on the control box screen.
For the method of changing the increase/decrease amount, see “METHOD FOR ADJUSTING CUT/FILL OFF-
SETS (4-80)”.
EXPLANATION OF COMPONENTS OPERATION
3-10