![Komatsu D375A-8 Operation & Maintenance Manual Download Page 37](http://html1.mh-extra.com/html/komatsu/d375a-8/d375a-8_operation-and-maintenance-manual_1991126037.webp)
KDPF is a device to purify the soot in the exhaust gas. Exhaust gas temperature may increase during the purifi-
cation process (regeneration). Do not bring any combustible material close to the outlet of the exhaust pipe.
When there are thatched houses, dry leaves or pieces of paper near the job site, set the system to the regener-
ation disable to prevent fire hazards due to highly heated exhaust gas during the aftertreatment devices regen-
eration.
Explosion caused by lighting equipment
When checking fuel, oil, battery electrolyte, or coolant, always use lighting with anti-explosion specifications.
PRECAUTIONS WHEN GETTING ON OR OFF MACHINE
USE HANDRAILS AND STEPS WHEN GETTING ON OR OFF MACHINE
To prevent personal injury caused by slipping or falling off the machine, always observe the following.
• Use the handrails and steps indicated by the arrow (A) in
the figure when getting on or off the machine.
Use the handrails and steps indicated by the arrow (B) on-
ly when moving along the top of the track or when check-
ing or performing maintenance inside the side cover, or
when filling the tank with oil. Never use them when getting
on or off the machine.
• Always face the machine and maintain at least three-point
contact (both feet and one hand, or both hands and one
foot) with the handrails and steps to ensure that you sup-
port yourself.
• Before getting on and off the machine, check the handrails
and steps if there is any oil, grease, or mud on them. Wipe
it off immediately if any, and take care not to slip. If there is
any loose bolt on the handrails and steps, tighten it se-
curely.
If the handrails and steps are damaged or deformed, they
need to be repaired immediately. Ask your Komatsu dis-
tributor to perform this work.
• Do not grip the control levers, parking brake lever, or work equipment lock lever when getting on or off the
machine. When getting on or off the machine, take care that your body or clothes do not touch the control
levers.
• Never climb on the engine hood or covers where there are no non-slip pads.
• Do not get on or off the machine with tools in your hand.
NO JUMPING ON OR OFF MACHINE
Getting on or off the moving machine can cause serious personal injury or death. Always observe the following.
• Never jump on or off the machine. Never get on or off a moving machine.
,&
SAFETY
GENERAL PRECAUTIONS COMMON TO OPERATION AND MAINTE-
NANCE
2-13
Summary of Contents for D375A-8
