HEAD LAMP SWITCH
The headlamp switch is used to light up the head lamp and
monitor illumination.
(A) Night position
Lamps light up and monitor illumination is set to night mode.
(B) Day position
Lamps light up and monitor illumination is set to day mode.
(C) OFF position
Lamps go out.
(The monitor illumination is set to day mode.)
REAR LAMP SWITCH
Use the rear lamp switch to light up the rear lamp.
(A) ON position
Rear lamp lights up.
(B) OFF position
Rear lamp goes out.
PIN PULLER OPERATION SWITCH
(only machines equipped with giant ripper)
The pin puller operation switch is used to operate the ripper
shank pin.
(a) Pull
The pin is pulled out.
(b) Push
The pin is pushed in.
(F): Front of machine
NOTICE
After turned the switch to PUSH position (b), check that
the pin is pushed in actually.
ROOM LAMP SWITCH
NOTICE
If the room lamp is left to be turned on, the batteries may be exhausted. Always turn the switch to OFF
position after using room lamp.
Use room lamp switch to light up the room lamp.
ON position
Lights up
OFF position
OFF
The room lamp lights up even when the starting switch is at
OFF position.
EXPLANATION OF COMPONENTS
OPERATION
3-96
Summary of Contents for D155AX-8E0
