MAINTENANCE PROCEDURES
205
4.8.6.d
LUBRICATING THE PROPELLER SHAFTS
WARNING
q
Carry out this operation with the machine parked on a level
surface, the work equipment resting on the ground and the
engine off.
The propeller shafts must be lubricated after thoroughly cleaning
the grease nipples, by applying the grease pump filled with the
prescribed grease.
(See "4.3 FUEL, COOLANT AND LUBRICANTS" and "4.5.1 LU-
BRICATION DIAGRAM").
Once the lubrication procedure has been carried out, make sure
that all the points have been lubricated and remove the used
grease that may have spread out of the joints.
IMPORTANT
q
If the machine is used in difficult conditions, carry out this
operation more frequently than usual.
RKAB3890
RKAB3900
RKAB3910
RKAB3920
Summary of Contents for F50003
