Komatsu Utility 69001, Operation & Maintenance Manual

Page: 108 / 276

OPERATION
OPERATION
3-54
6. Check for problems in handrails, steps, loose bolts.
If any problem is found, repair it. Tighten any loose bolts.
7. Check for problems in gauges and monitor
Check that there is no problem in the gauges and monitor in the operator's cab. If any problem is found,
replace the parts. Clean off any dirt on the surface.
8. Check for damage to seat belt and mounting clamps (if equipped)
Check that there is no abnormality in the seat belt or mounting clamps. If there is any damage, replace with
new parts.
CHECK BEFORE STARTING 3
Always check the items in this section before starting the engine each day.
CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL
WARNING
Parts and oil are at high temperature immediately after the engine is stopped and may cause serious
burns. Wait for the oil temperature to go down before performing this operation.
1. Open the engine side cover on the left side of the chassis.
2. Remove dipstick (G) and wipe the oil off with a cloth.
3. Fully insert dipstick (G) into filler pipe (F), then remove it.
4. The oil level should be between the H and L marks on dip-
stick (G).
If the oil level is below the L mark, add oil through oil filler
(F).