Komatsu Utility 15001, Operation & Maintenance Manual

Page: 46 / 234

PRECAUTIONS FOR MAINTENANCE
44
2.8 PRECAUTIONS FOR MAINTENANCE
2.8.1 WARNING PLATES
• Before starting any maintenance operation, position the ma-
chine on a firm and level surface, rest the equipment onto the
ground, engage the safety locks of either the equipment and the
controls and stop the engine.
• If another person starts the engine and operates the control le-
vers while the operator is providing for service, this may result
in serious injuries or even death.
• To avoid these risks, always attach warning plates to the control
levers and to the ignition key before performing any mainte-
nance operation; if necessary, attach additional warning tags al-
so around the machine and in particular on the cab door
handles.
2.8.2 TOOLS
• Use only the tools provided with the machine and high-quality
tools suitable for the tasks to be performed.
• Do not use worn, damaged, low-quality tools or tools that are
not suitable for the tasks to be performed, in order to avoid any
personal injury.
2.8.3 PERSONNEL
• Only authorized and duly trained personnel can service and repair the machine; additional precautions must be
taken when grinding, welding and using a sledge hammer or heavy hammers.
• When assemblying the equipment or cylinder connection pins, use wooden, plastic or in any case not excessive-
ly hard tools to check the centering of the holes.
Do not use your fingers, since you run the risk of cutting them.
RKA13300
NON
METTERE
IN MOTO
RKA00340
DO NOT
START
ENGINE
RKA00330