Kolver 033001, Operator'S Manual

Page: 59 / 89

Vers. 111422 59
CURRENT SEQ. menu
(1) Sequence letter
Indicates the sequence that is currently being edited.
Tap the arrows to select a different sequence to edit (A through H).
(2) Program number box
Tap to change or insert a program into the sequence. The sequence flows left to right, top
to bottom.
You can insert any of the 64 programs into any of the 16 spots in the sequence. You can
also insert the same program in different boxes if desired.
(3) Program transition box
Tap the box to define the transition behavior between the two corresponding programs
in the sequence.
The transition behavior can be:
Time : when the previous program is successfully completed, the unit will automatically
switch to the next program after the set amount of time, in seconds. The screwdriver will
remain disabled until the transition timer completes. The timer begins counting as soon
as the program is completed, even if the lever is not depressed or the remote start
command is not removed. The allowable range is 0.3 to 10 seconds.
OK : when the previous program is successfully completed, the “press OK” screen will
appear.
When this screen appears, the screwdriver will remain disabled until the operator taps
OK on the touch screen popup, or until the “REMOTE OK” external signal is received.
Auto : when the previous program is successfully completed, the unit will immediately
switch to the next program WITHOUT having to depress the screwdriver lever or pull
down the remote start command. This setting can be useful if you require multiple
closing torques or angles on the same joint without stopping in between, or to create a
screwdriving operation that is not otherwise possible within the parameters of a single
program.