Kollmorgen SERVOSTAR 300, Safety Manual

Page: 35 / 154

2.2 Safety
This section helps you to recognize and avoid dangers to people and objects.
2.2.1 You should pay attention to this
Specialist staff required!
Only properly qualified personnel are permitted to perform such tasks as transport,
assembly, setup and maintenance. Qualified specialist staff are persons who are familiar
with the transport, installation, assembly, commissioning and operation of drives and who
bring their relevant minimum qualifications to bear on their duties:
Transport: only by personnel with knowledge of handling electrostatically sensitive com-
ponents.
Unpacking: only by electrically qualified personnel.
Installation: only by electrically qualified personnel.
Basic tests / Setup: only by qualified personnel with knowledge of electrical engineering
and drive technology
The qualified personnel must know and observe ISO 12100 / IEC 60364 / IEC 60664 and
national accident prevention regulations.
Read the documentation!
Read the available documentation before installation and commissioning. Improper handling
of the servo amplifiers can cause harm to people or damage to property. The operator must
therefore ensure that all persons entrusted to work on the have read and understood the
manual and that the safety notices in this manual are observed.
Check the Hardware Revision!
Check the Hardware Revision Number of the product (see product label). This revision num-
ber must match the Hardware Revision Number on the cover page of the manual. If the num-
bers do not match up, visit the Tech-WIKI ( (
http://www.wiki-kollmorgen.eu ). The 'Download'
section contains the various manual versions based on the hardware version number.
Pay attention to the technical data!
Adhere to the technical data and the specifications on connection conditions (rating plate and
documentation). If permissible voltage values or current values are exceeded, the servo amp-
lifiers can be damaged.
Observe electrostatically sensitive components!
The servo amplifiers contain electrostatically sensitive components which may be damaged
by incorrect handling. Discharge your body before touching the servo amplifier. Avoid con-
tact with highly insulating materials (artificial fabrics, plastic film etc.). Place the servo amp-
lifier on a conductive surface.
Perform a risk assessment!
The manufacturer of the machine must generate a risk assessment for the machine, and
take appropriate measures to ensure that unforeseen movements cannot cause injury or dam-
age to any person or property. Additional requirements on specialist staff may also result
from the risk assessment.
S300 Safety Guide | 2 English
Kollmorgen | wiki-kollmorgen.eu | December 2015 35