Kollmorgen EB-10 Series, Instruction Manual

Page: 11 / 96

1.3.4 Certifications & Approvals
1.3.4.1 UL
See Model Number Description for models that meet UL. EB-models that meet UL are for use in
Class 1, Division 1, Groups C and D hazardous locations.
1.3.4.2 ATEX/IECEx/CCC/ETL
See Model Number Description for models that meet ATEX/IECEx.
l
EB-models that meet ATEX / IECEx are for use in IECEx/ATEX Ex II 2 G Ex d IIB T3 Gb -40°C ≤ Ta
≤ +40deg°C .
l
ATEX/IECEx configurations also include the China Compulsory Certificate ( CCC ) mark.
l
Currently the EB-80x series is not offered in ATEX/IECEx or CCC.
1.3.5 Motor Inspection
Remove the motor from the shipping container being careful not to damage the leadwires
extending from the connection fitting. Do not lay the motor on top of the leadwires as it may
damage the wires. Visually inspect the motor for any shipping damage that may have occurred.
l
Motor frame and exterior covers are to be free of nicks, burrs, or upsets with all motor
fasteners in place and tight.
l
Output shaft & keyway are to be free of nicks, burrs, or blemishes that would prevent safe
assembly of mechanical connections.
l
Front endbell flange and mounting pilot are to be free of nicks, burrs, or damage that would
prevent proper motor mating or alignment to mounting surfaces and diameters.
l
Mounting holes are to be free of damage or debris that would prevent installation of
mounting fasteners.
l
Leadwires are to be free of nicks, cuts, or cracked insulation that expose bare wire.
l
If damage is noted or suspected, notify shipping carrier immediately.
Goldline EB Instructions | 1 English
Kollmorgen | kdn.kollmorgen.com | August 2021 11