K3 IMU
- 40 -
L-band: The radio frequency range of 390-1550MHz.
Multipath error: the positioning error caused by the interference between two or more
radio signal propagation path.
Observing session: the use of two or more receivers at the same time to collect GPS
data period.
Pseudo Range: GPS receiver in the time required to copy the code aligned with the
received GPS code offset and multiplied by the speed of light to calculate the distance.
This time offset is the difference between the signal reception time (time series of the
receiver) and the signal emission time (satellite time series).
Receiver channel: GPS receiver RF mixer and IF channel, can receive and track
satellites two carrier signals.
Satellite configuration: the configuration status of the satellite with respect to a
specific user or a group of users within a specific time.
Static position: do not consider the point of measurement of the movement of the
receiver.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes
or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
