Owner’s Manual
6CC10BEA2AA00
13
Installation Guide
MOVING THE UNIT
Please lift and carry more than 2 people. If casters are set to the unit, unlock the casters and
push the unit to a flat, level surface and set the caster brakes to the locked position.
PLUGGING THE UNIT
Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are pres-
ent, wipe off with a clean, dry cloth.
Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact a qualified repair technician or a qualified electri-
cian to perform replacement or repair of the power cord, plug or prongs.
NOTE:
Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign material. The
unit is equipped with an approved NEMA plug configuration. (6CC10BEA2AA00: 5-15P)
The appropriate outlet must be used for each plug type.
WARNING REGARDING PROPER LOCATION FOR INSTALLATION
Do not use the unit in explosive environments or in areas where flammable
gas leakage may occur.
Do not use the unit in a corrosive atmosphere.
Do not use the unit above 18˚C(64.4˚F)~45˚C(113˚F)
Do not install the unit on uneven or sloping surface. The unit may roll or top-
ple over even if the casters are set to the locked position.
If the power cord or plug is damaged, repair should only be performed by
qualified electrical personnel.
Do not connect/ disconnect the power cord or attempt to operate buttons
with wet hands. This could result in electrical shock.
