Koldfront KIM450BL Owner'S Manual Download Page 21

17 

 

 

EdgeStar Limited Warranty 

Full One-year Parts and Labor 

This product is warranted by EdgeStar and is subject to any conditions set forth as follows:

 

WHAT IS COVERED:

 

For a period of ONE (1) YEAR from the date of original retail purchase, EdgeStar will repair or replace any part free of charge 
including labor that fails due to a defect in materials or workmanship. Labor will be performed free of charge at an authorized 
EdgeStar repair facility and EdgeStar will supply new, rebuilt, or refurbished parts free of charge. EdgeStar may request a defective 
part be returned in exchange for the replacement part. All replacement parts or products will be new, remanufactured, or 
refurbished. All products and parts replaced by EdgeStar under warranty service become the property of EdgeStar. After the 12 
month period, EdgeStar will no longer be responsible for labor charges incurred or replacement parts. All defective products and 
parts covered by this warranty will be repaired or replaced on a mail-in basis to an EdgeStar authorized repair facility.

 

This warranty applies to the original purchaser only, and only covers defects in workmanship experienced during operation of the 
product under normal service, maintenance, and usage conditions. This warranty applies to the purchase and use of this product in 
residential settings within the contiguous 

United States of America.

 

Exceptions: Commercial or Rental Use

 

Warranty

 

90 days labor and parts from date of original purchase. No other warranty applies. 

 

WHAT IS NOT COVERED

- The following limitations apply to the coverage of this warranty. This warranty does not cover:

 

-Labor charges for installation, setup, or training to use the product.

 

-Shipping damage, and any damage caused by improper packaging for shipment to an authorized service center, and any 
damaged caused by improper voltage or any other misuse, including abnormal service, handling, or usage.

 

-Cosmetic damage such as scratches and dents.

 

-Normal wear and tear on parts or replacement of parts designed to be replaced, e.g. filters, cartridges, batteries.

 

-Service trips to deliver, pick-up, or repair, install the product, or to instruct in proper usage of the product.

 

-Damages or operating problems resulting from misuse, abuse, operation outside environmental specifications, uses contrary to 
instructions provided in the owne

r’s ma

nual, accidents, acts of God, vermin, fire, flood, improper installation, unauthorized service, 

maintenance negligence, unauthorized installation or modification, or commercial use.

 

-Labor, service transportation, and shipping charges for the removal and replacement of defective parts, beyond the initial 12 
month period.

 

-Products that have been modified to perform outside of specifications without the prior written permission of EdgeStar.

 

-Products lost in shipment, or theft.

 

-Products sold AS IS or from an unauthorized reseller.

 

-Products that have had their serial numbers removed, defaced, or with serial numbers that have been invalidated.

 

-Damage from other than normal household use.

 

-Replacement or repair of household fuses, circuit breakers, wiring or plumbing.

 

-Damage to personal property from use of product.

 

-Damage from service other than from an authorized EdgeStar repair facility.

 

-Hoses, knobs, lint trays and all attachments, accessories and disposable parts.

 

-Any service charges not specifically identified as normal such as normal service area or hours.

 

-Any special or consequential damages arising out of the use of the product. 
 

OBTAINING WARRANTY SERVICE: 

If you believe your product is defective, contact EdgeStar Customer Support for 

troubleshooting assistance and warranty service at 

www.edgestar.com 

or call 1-866-319-5473. Before contacting Customer Support 

you are required to have your model number, serial number, and proof of purchase available upon request. Once an EdgeStar 
authorized representative has confirmed that your product is defective and eligible for warranty service, the product must be 
returned to an EdgeStar authorized repair facility. EdgeStar is not responsible for damage resulting from shipper mishandling or 
improper packaging. Do not return a defective product to the place of

 

purchase. Products received without a return authorization 

number will be refused. 

 

THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A 
PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE. NEITHER THE 
MANUFACTURER NOR ITS DISTRIBUTORS SHALL BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY NATURE, INCLUDING 
WITHOUT LIMITATION, LOST REVENUES OR PROFITS, OR ANY OTHER DAMAGE WHETHER BASED IN CONTRACT, TORT, OR 

OTHERWISE. 

IN NO EVENT AND UNDER NO 

CIRCUMSTANCE OF ANY TYPE OR KIND SHALL THE SELLER, MANUFACTURER AND/OR DISTRIBUTOR BE LIABLE FOR ANY REASON, UNDER ANY 
THEORY, FOR MORE THAN THE BASIC COST OF THE PRODUCT TO THE PURCHASER OR END USER.

 

SOME STATES DO NOT ALLOW THE EXCLUSION OF 

INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER 
RIGHTS THAT VARY FROM STATE TO STATE.

 

Summary of Contents for KIM450BL






















Reviews: