ASSEMBLY AND OPERATING INSTRUCTIONS LIKEtoBIKE 16
Please read this manual carefully before using the LIKEtoBIKE for the first time!
The assembly must be done by an adult!
1. Remove all packaging mar Reflectors, Touch-up paint, Instruc-
tions.aterials. Contents of the enclosed accessory box are: Pe-
dals, hexagon tool (Allen key) (4mm,5mm,6mm),
Front and Rear
Reflectors and Instructions.
Adjusting screw for
headset play
3. Loosen the setscrew adjustment screw and remove the
transport packaging.
transport packaging
4. Place the stem with the handlebar already mounted on the
steerer tube and adjust the headset using the headset adjustment
screw.
Very important: With this screw you adjust only the
headset play! This screw is not used to attach the stem!
Now align the handlebar in the direction of travel and tighten
the attachment screws for the stem with a 5 mm Allen key (torque
18 Nm).
2.After loosening the seat post clamp screw, slide the seat
post into the seat tube.
Important: It is essential to observe the minimum in-
sertion depth of the saddle support! This is indicated
by a marking line on the seatpost! The saddle
support must not be pulled out beyond this mark, as other-
wise a secure connection to the seat tube is not guaranteed!
The saddle can be adjusted after loosening the saddle faste-
ning screw in the longitudinal direction and inclination. Then
tighten this screw again (torque 15 Nm)!
Adjusting the correct saddle height: Place a pedal in the lo-
west position. If the child is sitting on the saddle, it must be
able to touch this pedal with his heel outstretched. Make sure
that the hips remain horizontal and do not tip over to the side!
Saddle fastening
screw
Seat post clamping
screw
Mounting screws for
stem
Adjustment for
headset clearance
(NOT TO FIX THE
STEM!)
right pedal
left pedal
5. Now mount the pedals. Turn the pedal axles by hand until snug!
Then tighten with a 15 mm wrench.
Important: The right pedal is mounted clockwise, the
left pedal counterclockwise! The pedals are marked on
the pedal axle with an „R“ for the right pedal and an „L“ for
the left. It is important to remember this if you need to loosen the
pedal axle someday. So that the pedals can easily be loosened
again later, grease them lightly before mounting.
After the first long ride please check that the pedals
are seated firmly! Loose pedals could damage the th-
read of the cranks or cause a fall!
