qb701 User
’s
Manual
31
Multipoint
mode
–
measurements may be taken at any minimum 3 up to 36 positions.
After taking enough readings one should press
to proceed to the result screen. For
Vertical machines inclinometer data is unavailable, so angle value for each point should be
entered manually, taking into account mentioned above positions conventions.
Press
to enter tolerance setup menu.
Press
to use predefined RPM/tolerance table
Press
to enter user defined tolerance values
Press
to save changes,
to discard changes.
TAKING MEASUREMENTS. CLOCK MODE
Press
to edit dimensions.
Mark on the machine measurement positions separated by 90
°
(or
45
°
)
Set parameters and enter dimensions then press
key to
proceed.
Turn shafts to first position
–
9 o’clock (90°)
Press
to take first reading.
9
