INFORMATION
ABOUT REPLACEMENTS
6
47
EN
6
INFORMATION ABOUT REPLACEMENTS
6.1
Engine oil replacement
Danger:
•
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
Important:
•
Before proceeding with operation, read
Important :
•
Place engine on level surface to ensure accurate
measurement of oil level.
Before proceeding, perform the operation described in
NOTE: Perform this operation with warm engine, to get a
better fluidity of the oil and get a full discharge of oil and
impurities contained in it.
6.1
1.
Loosen the oil filler cap A (Fig. 6.1).
2.
Remove the oil dipstick B.
3.
Remove the oil drain plug D and the gasket E (the oil
drain plug is on both sides of the oil sump).
4.
Drain oil in an appropriate container (For the exhausted
oil disposal, refer to (
5.
Replace gasket E.
6.
Tighten the drain oil plug D (tightening torque at 50 Nm).
7.
Perform the operation described in
6.2
8.
Add the type oil recommended (
and
Important :
•
Do not exceed the MAX level on the dipstick.
•
Do not use the engine with the oil level below the MIN.
9.
Fit and remove the oil dipstick B to check the level. Pour
in fluid until reaching the MAX level mark.
10.
Upon completion, reinstall the oil dipstick B completely.
11.
Tighten the cap A.
6.3
NOTE:
Click on the icon to play the procedure.
https://www.youtube.com/
embed/T7XFP3Vn_q0?rel=0
Summary of Contents for KDI 3404TCR-SCR
