Kohler KDI 1903M, Owner'S Manual

Page: 30 / 40

6
_14
30
D
A
A
C
B
D
E
6.2
6.3
6.1
EN
INFORMATION ABOUT REPLACEMENTS
6.1 Engine oil replacement
Important
• Place engine on level surface to ensure accurate
measurement of oil level.
NOTE: Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A (Fig. 6.1).
2. Remove the oil dipstick B.
3. Remove the oil drain plug D and the gasket E (the oil drain
plug is on both sides of the oil sump).
4. Drain oil in an appropriate container.
(For the exhausted oil disposal, refer to
Par. 6.6 DISPOSAL and SCRAPPING ).
5. Replace gasket E.
6.
Tighten the drain oil plug D (tightening torque at 35 Nm).
7. Perform the operation described in Par. 6.2 .
8. Add the type oil recommended ( Tab. 21 and Tab. 2.2 ).
9. If the plug A is not accessible, use the oil filler cap C.
Important
• Do not exceed the MAX level on the dipstick.
Danger
•
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
Important
•
Before proceeding with operation, read Par. 3.3.2 .
ED0053029510
Index